Browsing by Title

Effects of Processing Parameters on P(L/D)LA 96/4 Fibers and Fibrous Products for Medical Applications

Ellä, Ville (2012-05-04)

Tissue engineering is expected to fulfill its promises to produce knowledge, methods, and products that would benefit the health care sector. The need of a degradable construct is a necessity when trying to grow a living ...

Effects of repeaters on UMTS network performance

Lähdekorpi, Panu (2006-03-08)

AB3:Radioverkkosuunnittelijat pyrkivät suunnittelemaan matkaviestinverkon, jossa suorituskyky on mahdollisimman hyvä ja toteutuskustannukset mahdollisimman pienet. Työkalujen valinnalla ja huolellisella suunnittelulla on ...

The effects of river water infiltration on sub-surface microbiology and physico-chemical water characteristics in a pristine aquifer

Hagelin, Titta (2012-04-04)

Artificial groundwater recharge (AGR) and bank filtration (BF) are old, widely applied methods to produce drinking water by the infiltration of surface water through soil. These methods are increasingly used because they ...

Effects of sand composition on CO oxidation in FBC

Ilkka, Lisa (1999-03-10)

Fluidized bed sand is usually treated as an inert material though it is the main solid component in the bed. The sand can consist of a wide range of different components. In this study the effects of the fluidized bed sand ...

Effects of strain rate and temperature on the tensile properties of austenitic stainless sheet steels

Isakov, Matti (2008-02-06)

In the thesis the mechanical behaviour of austenitic stainless steels was studied at different strain and temperatures. There has been an increasing demand for this kind of research during the past few decades due to the ...

Effects of temperature and humidity on the dielectric properties of thermally sprayed ceramic coatings

Rotthier, Bram (2012-06-06)

Electrical insulation is indispensable in electrical equipment. Thermally sprayed ceramic coatings are promising materials, offering insulating capabilities in areas where other materials do not fulfil the requirements. ...

Effects of the Human Body on Single-Layer Wearable Antennas

Kellomäki, Tiiti (2012-03-23)

The effect of the human body on wearable off-body communication antennas is studied in the frequency range from 100 MHz to 2.5 GHz. Special emphasis is on single-layer structures, with metallisation in one layer only. In ...

Effects of the Metor 200 and Metor 300 walk-through metal detectors on some active implantable and external medical devices

Kekkonen, Jalmari (2006-10-11)

People screening systems, such as walk-through metal detectors, are continually increasing. At the same time an ever increasing number of people are carrying an active implantable medical device, e.g. a cardiac pacemaker ...

Effects of transcriptional pausing on gene expression dynamics

Rajala, Tiina; Häkkinen, Antti; Healy, Shannon; Yli-Harja, Olli; S. Ribeiro, Andre (2010)

Stochasticity in gene expression affects many cellular processes and is a source of phenotypic diversity between genetically identical individuals. Events in elongation, particularly RNA polymerase pausing, are a source ...

The effects of wood derived compounds on biological treatment

Järvinen, Johannes (2007-10-17)

Wood derived compounds are major source of toxicity in pulp and paper industry's effluents. The toxic effects on receiving waters and removal with biological treatment has been studied, but Iittle attention has been paid ...

The efficient commissioning of capital equipment

Li, Xiufeng (2012-11-07)

Commissioning is a critical phase of project delivery which is the continuity of previous project management preparation after the negotiations and contracts and prelude of service business in the future. Commissioning ...

Efficient design and implementation of uniform single-rate linear-phase FIR filter banks

Anjum, Omer (2007-06-06)

Linear digital filters are often the essential and most important parts of digital signal processing systems. Based on these digital filters, the interest in digital filter banks has grown dramatically over the last two ...

Efficient Routing Protocol in Delay Tolerant Networks (DTNs)

Karimzadeh, Morteza (2011-06-08)

Efficient second-harmonic generation in silicon nitride resonant waveguide gratings

Ning, Tingyin; Pietarinen, Henna; Hyvärinen, Outi; Kumar, Ravi; Kaplas, Tommi; Kauranen, Martti; Genty, Goery (2012-10)

We demonstrate a thousand-fold enhancement of second-harmonic generation in an all-dielectric silicon nitride (SiN) resonant waveguide grating compared to a flat SiN film. The strong second-harmonic output measured at 532 ...

EGPRS on layer 1 in a GSM mobile station

Virtanen, Ilkka (2006-01-18)

The aim of this thesis work was to find out which parameters are essential in integrating EGPRS protocol to the DSP of a mobile phone. The work should be used as support and reference in the actual integration work. The ...

Ehdotus Puolustushallinnon rakennuslaitoksen kiinteistökustannusten laskentamalliksi

Kaarina, Vainio (1993)

Puolustushallinnon kiinteistö-ja rakennustoimen viranomais- ja palvelutehtävät keskitetään puolustushallinnon rakennuslaitokselle. Rakennuslaitoksen aloittaessa toimintansa 1.4.1994 sen tarjoamat palvelut muuttuvat käyttäjille ...

Ehdotustoiminta rakennusyrityksessä

Seini, Matias (2003-06-04)

Diplomityön tavoitteena oli luoda rakennustoimistolle toimiva ehdotusjärjestelmä. Tämän järjestelmän avulla mahdollistetaan yrityksen koko henkilöstön osallistuminen organisaation kehittämiseen, vaikuttaminen sen toimintaan, ...

Ei kysyvä teekkari opintopolulta eksy. TTY:n ohjauskyselyn 2010 tuloksia

Pajarre, Eila; Asunmaa, Piia; Lukkari, Heli (2011-04)

Tämän tutkimuksen lähtökohtana oli selvittää yliopisto-opiskelijoiden kokemuksia opintoihinsa liittyvästä ohjaustarpeesta ja saamastaan ohjauksesta. Toisena tavoitteena oli kartoittaa opiskelijoiden opiskeluaikaista ...

EKG-laitteen mittauselektroniikan ja mittausohjelmien suunnittelu

Eskelä, Esa (1984)

KONE-EKG -järjestelmä on elektrokardiologinen tutkimusjärjestelmä, joka koostuu useista laitteisto- ja ohjelmistokokoonpanoista sovitettuna erilaisten EKG-tutkimusten tarpeisiin. Yksi järjestelmän perusyksiköistä on ...

EKG-laitteen perusohjelmiston suunnittelu ja sovittaminen EKG-analysaattoriin

Korvenmaa-Mölsä, Päivi (1985)

KONE-EKG-järjestelmä on elektrokardiografinen tutkimusjärjestelmä. Sen useat vaativia EKG-tutkimuksia palvelevat tuotteet ovat mikroprosessoripohjaisen perusmittalaitteen erilaisia sovelluksia. Tarkoituksena oli suunnitella ...

Kirjasto - Tampereen teknillinen yliopisto

Kirjasto

Browsing by Title

Search TUT DPub

Browse

All of TUT DPub

My Account